~~DISCUSSION:off~~ ===== INSTALLING T-POST CAMERA MOUNT ===== |Align the threads of the T-post mounting \\ bracket to the camera mounting port. \\ Thread bracket no more than three \\ complete rotations our it may damage the \\ camera housing. Tighten securely using \\ the adjusting nut. |{{:wiki:mine_trap:installation:camera-mount-1.png?nolink&200|}} | |Mount the M.I.N.E.™ Cam to post #24 \\ outside the enclosure according to the \\ page 14 diagram. Lower the square collar \\ at a diagonal over the post spine and \\ studs. |{{:wiki:mine_trap:installation:camera-mount-2.png?nolink&200|}} | |Lower the collar into position between \\ any two studs. Insert the mounting wedge \\ between the post spine and square collar. |{{:wiki:mine_trap:installation:camera-mount-3.png?nolink&200|}} | |Tighten the mounting wedge thumb screw \\ against the post spine to se-cure the \\ camera mount. |{{:wiki:mine_trap:installation:camera-mount-4.png?nolink&200|}} | |Align the camera by loosening the ball \\ head set screw and centering the view \\ on the ground beneath the feeder legs. \\ Tighten the ball head set screw to secure \\ the camera. |{{:wiki:mine_trap:installation:camera-mount-5.png?nolink&200|}} | ---- ---- {{backlinks>.}}