~~DISCUSSION:off~~

===== MOUNTING ANTENNA TO CONTROL BOX =====

|Carefully feed the antenna through \\ the rubber grommet without \\ damaging the receiver inside the \\ control box. |{{:wiki:mine_trap:installation:control_box:mounting-antenna-1.png?nolink&200}} |
|Feed the antenna wire through the \\ 1/8” diameter antenna tube until it \\ clears the opposite end. |{{:wiki:mine_trap:installation:control_box:mounting-antenna-2.png?nolink&200}} |
|Slide the antenna tube into the \\ rubber grommet until it becomes \\ visible inside the control box. This \\ waterproof seal with help keep \\ electrical components clean and \\ dry during field use. |{{:wiki:mine_trap:installation:control_box:mounting-antenna-3.png?nolink&200}} |
|The antenna wire in this position \\ rests between two horizontal gate \\ frames and will receive a wireless \\ signal from 250 meters (or 275 \\ yards) when using the long range \\ transmitter. |{{:wiki:mine_trap:installation:control_box:mounting-antenna-4.png?nolink&200}} |

----
----

{{backlinks>.}}