~~DISCUSSION:off~~

===== INSTALLING CONNECTING ROD & CLEVIS =====

|Push the 1/8” connecting rod through the plastic clevis. |{{:wiki:mine_trap:installation:install-rod-1.png?nolink&200  }} |
|Slide the connecting rod through the actuator hole \\ inside the control box. |{{:wiki:mine_trap:installation:install-rod-2.png?nolink&200  }} |
|Align the slots and gently snap the clevis onto \\ the actuator arm. |{{:wiki:mine_trap:installation:install-rod-3.png?nolink&200  }} |
|Rotate the connecting rod and clevis to this position. \\ Work the rod back & forth to ensure there is no binding. |{{:wiki:mine_trap:installation:install-rod-4.png?nolink&200  }} |
|{{:wiki:warning.png?nolink&25  }}NEVER transport the M.I.N.E. Gate with battery \\ inside the control box or severe damage to \\ electronics and battery will occur. \\ Remove battery during transport and always \\ disconnect when not in use. |{{:wiki:mine_trap:installation:install-rod-5.png?nolink&200  }} |

----
----

{{backlinks>.}}