wiki:camera:mine:installation:quick_setup
Differences
This shows you the differences between two versions of the page.
|
wiki:camera:mine:installation:quick_setup [2015/06/29 07:37] |
wiki:camera:mine:installation:quick_setup [2021/12/15 12:07] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ===== CAMERA QUICK SETUP ===== | ||
| + | 1. Ensure selector switch is OFF and install 8 new AA lithium | ||
| + | batteries according to polarity symbols. \\ | ||
| + | 2. Insert an activated SIM card and formatted SD card (32GB | ||
| + | or smaller) into the appropriate camera slots. \\ | ||
| + | 3. Move the selector switch from OFF to SETUP. \\ | ||
| + | 4. The screen will display Checking then Searching as the | ||
| + | camera acquires a cellular signal. \\ | ||
| + | 5. The camera has successfully acquired a cellular signal | ||
| + | when six numbers or the service provider’s initials appear on | ||
| + | the display. Failure to connect will prevent the camera from | ||
| + | sending texts and photos via MMS. | ||
| + | |||
| + | {{ : | ||
| + | |||
| + | **Note: Allow approximately 10-20 seconds for the camera | ||
| + | to acquire a cellular signal. If “LOGIN FAIL” appears on | ||
| + | the display, move the selector switch OFF and repeat | ||
| + | steps. The 5 db booster antenna (accessory) is necessary | ||
| + | for cellular operation in low signal areas.** | ||
| + | | ||
| + | 6. Place the camera at the target area at least five feet above | ||
| + | ground level using a T-Post and T-Post Camera Mount. This | ||
| + | will ensure the camera has the correct angle to trigger the PIR | ||
| + | motion sensor and IR illuminators are above the target area. \\ | ||
| + | 7. Slide the selector switch from **SETUP** to **ON**. Close and | ||
| + | latch the camera within ten seconds before the Ambient Light | ||
| + | Sensor LED stops blinking red and the PIR triggers a photo. \\ | ||
| + | 8. Ensure the camera takes a photo to verify it is positioned | ||
| + | and programmed correctly. The camera will take photos or | ||
| + | videos based on the **MENU** selections. The M.I.N.E.™ Cam is | ||
| + | now operational and active. \\ | ||
| + | |||
| + | **NOTE: If the Ambient Light Sensor LED does not stop | ||
| + | blinking, the selector switch is still in the SETUP position. | ||
| + | The camera must be ON to function.**\\ | ||
| + | < | ||
| + | < | ||
| + | with the entire M.I.N.E.™ Trapping System video series at: <a href=" | ||
| + | </ | ||
| + | |||
| + | ---- | ||
| + | ---- | ||
| + | |||
| + | {{backlinks> | ||
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
