ADJUSTING TRIGGER ASSEMBLY

Loosen the trigger assembly nuts with a
9/16” wrench.
Adjust the trigger assembly left or right until
the trigger square stock is sitting on the
outside edge of the trip arm. Then tighten
the trigger assembly nuts with a 9/16”
wrench. The trigger is set at the factory
and should not require adjustment.
Lightly tighten the bolt and nut on the
trip arm using a 1/2” wrench and socket
so the trip arm stays in the “up” position
without falling, but can still easily move.
Work the trip arm up and down onto the
latch to ensure there is no binding.

It is important the trip arm stays
in the “up” position without falling. This
step allows the use of both hands to raise
the gate.