User Tools

Site Tools


wiki:camera:3g:installation:characteristics

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

wiki:camera:3g:installation:characteristics [2015/06/30 13:57]
wiki:camera:3g:installation:characteristics [2021/12/15 12:07] (current)
Line 1: Line 1:
 +===== CAMERA CHARACTERISTICS ===== 
 +
 +This manual is intended to visually guide users through the individual steps  
 +to properly program, operate and maintain the 3G GSM version of our  
 +JAGER PRO M.I.N.E™ and I.C.E.™ Cameras. \\
 +
 +{{ :wiki:camera:3g:3g-cam-char.png?nolink&250 |}}
 +
 +**1.  Antenna:** Standard antenna shown receives cell tower signals. Our 5  
 +decibel booster antenna is available as an accessory for operation in low  
 +signal areas. \\
 +**2.  IR Illuminator:** 44 infrared LEDs that illuminate the target area when  
 +camera functions at night. \\
 +**3.  Camera Lens:** The camera lens has a 52 degree field of view with no  
 +magnification. This enables users to observe a 20’ field of view measured 15’  
 +from the lens and a 32’ field of view when measured 21’ from the lens. \\ 
 +**4.  PIR Sensor:** Passive Infrared motion detector. Senses the presence of  
 +a moving object which triggers the camera to take a photo or record a video. \\
 +**5.  Ambient Light Sensor:** Detects surrounding light to automatically  
 +control day and night camera functions. This sensor also emits a red,  
 +blinking LED when the selector switch is moved to **SETUP**.  The LED will  
 +stop blinking within 10 seconds after the selector switch is moved from  
 +**SETUP** to **ON** indicating the camera is operational and active. \\
 +**6. Locking Latch:** Secures the camera front housing to the main body  
 +housing while providing a waterproof seal to internal components. \\
 +
 +{{ :wiki:camera:3g:3g-cam-char-btm-out.png?nolink&300 |}}
 +
 +**1. DC Port Plug:** Waterproof seal to protect internal components when  
 +external battery (optional equipment) is not in use. \\
 +**2. Mounting Port:** 1/4 x 20 internal threads for securing camera to a  
 +T-Post mount. Only thread external devices two complete rotations into the  
 +camera mounting port then tighten using the mount’s adjusting nut. Forcing  
 +external threads to the bottom will damage mounting port and camera  
 +housing. \\
 +**3. USB Port Plug:** Waterproof seal to protect internal components when  
 +USB cable is not in use. \\
 +
 +{{ :wiki:camera:3g:3g-cam-char-ext-btry.png?nolink&300 |}}
 +
 +{{ :wiki:camera:3g:3g-cam-char-inside.png?nolink&400 |}}
 +
 +**1. Antenna Port:** Attachment point to install various antennas depending  
 +on local cellular strength. Our 5 db booster antenna is available as an  
 +accessory for operation in low signal areas. \\
 +**2. Display:** Screen to observe menus, photos and settings. 
 +3. Selector Switch: Used to enter into any of the three operating modes:  
 +**OFF**, **SETUP** and **ON**. \\
 +**4. Menu Button:** Used to select various camera options. \\
 +**5. Move Left Button:** Moves from the highlighted area to a selection left. \\
 +**6. Move Up Button:** Moves from the highlighted area to a selection  
 +above. \\
 +**7. Move Right Button:** Moves from the highlighted area to a selection  
 +right. \\
 +**8. Move Down Button:** Moves from the highlighted area to a selection  
 +below. \\
 +**9. OK Button:** Selects the highlighted item. \\
 +**10. DC Port:** 6 volt connection for external battery optional battery pack. \\
 +**11. USB Port:** Standard USB cable connection interface to transfer  
 +information between the camera and a computer. \\
 +**12. Battery Polarity Symbols:** Located on the front of the battery tray.
 +Aids in 12 proper battery polarity and installation. \\
 +**13. Playback Button:** Allows user to view pictures on SD card. \\
 +**14. Del Button:** Deletes unwanted pictures, numbers, and letters.\\
 +
 +{{ :wiki:camera:3g:3g-cam-char-left-side.png?nolink&300 |}}
 +
 +**1. SIM Card Port:** Slot for receiving a cellular SIM card from GSM network  
 +providers such as AT&T and T-Mobile. \\
 +**2. SD Card Port:** Slot for receiving an SD card. The camera has no  
 +internal memory. An SD card smaller than 32GB must be used to store  
 +photos, video and GSM data. \\
 +
 +----
 +----
 +
 +{{backlinks>.}}
 +