Southern Hog Control

Begin programming the M.I.N.E™ Camera for operation by removing the protective cap and installing the standard antenna onto the antenna jack. Ensure the black rubber O-ring is not removed from the antenna jack threads. Twist the antenna base snug but do not over tighten.

Unlock the full length locking latch to access the main body. Follow the battery polarity symbols located on the front of the battery tray to properly install 12 each batteries. We only recommend Energizer brand AA Lithium batteries for the best performance in the field. Alkaline or rechargeable AA batteries will not operate high-tech equipment nearly as long.

The camera will function in emergency situations using only four AA Lithium batteries in the two left columns. We recommend our 6 volt external power supply for extended, long-term camera use in the field. AA Lithium batteries are still required for initial start-up until the camera housing is closed and the 6 volt external power supply cable is inserted into the camera battery port.

Insert an activated SIM card into the SIM card port with the notch located in the top right-hand corner. A formatted SD card must be used for the camera to function. Move the selector switch from OFF to SETUP. The camera will immediately power OFF after the logo is displayed.

The camera supports up to a 32 GB SD card. Ensure the SD card is not locked and insert it into the SD card port. Move the selector switch from OFF to SETUP. The screen will display “Searching Network” at the bottom center of the screen. It usually takes 20 to 30 seconds for the camera to find the network. AT&T or T-Mobile will appear in the top center of the screen after connecting to the network and the signal strength symbol will appear in the top right.

.