This shows you the differences between two versions of the page.
wiki:camera:3g:installation:quick_start [2015/06/30 14:05] |
wiki:camera:3g:installation:quick_start [2021/12/15 12:07] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== QUICK START PROGRAMMING ===== | ||
+ | | ||
+ | Begin programming the M.I.N.E™ Camera for operation by removing the | ||
+ | protective cap and installing the standard antenna onto the antenna jack. | ||
+ | Ensure the black rubber O-ring is not removed from the antenna jack | ||
+ | threads. Twist the antenna base snug but do not over tighten. \\ | ||
+ | Unlock the full length locking latch to access the main body. Follow the | ||
+ | battery polarity symbols located on the front of the battery tray to properly | ||
+ | install 12 each batteries. We only recommend Energizer brand AA Lithium | ||
+ | batteries for the best performance in the field. Alkaline or rechargeable AA | ||
+ | batteries will not operate high-tech equipment nearly as long. \\ | ||
+ | |||
+ | The camera will function in emergency situations using only four AA Lithium | ||
+ | batteries in the two left columns. We recommend our 6 volt external power | ||
+ | supply for extended, long-term camera use in the field. AA Lithium batteries | ||
+ | are still required for initial start-up until the camera housing is closed and the | ||
+ | 6 volt external power supply cable is inserted into the camera battery port. \\ | ||
+ | |||
+ | Insert an activated SIM card into the SIM card port with the notch located in | ||
+ | the top right-hand corner. A formatted SD card must be used for the camera | ||
+ | to function. Move the selector switch from **OFF** to **SETUP**. The camera will immediately power **OFF** after the logo is displayed. \\ | ||
+ | |||
+ | The camera supports up to a 32 GB SD card. Ensure the SD card is not | ||
+ | locked and insert it into the SD card port. Move the selector switch from **OFF** | ||
+ | to **SETUP**. The screen will display “Searching Network” at the bottom center | ||
+ | of the screen. It usually takes 20 to 30 seconds for the camera to find the | ||
+ | network. AT&T or T-Mobile will appear in the top center of the screen after | ||
+ | connecting to the network and the signal strength symbol will appear in the | ||
+ | top right.\\ | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | ---- | ||
+ | ---- | ||
+ | |||
+ | {{backlinks> |