This shows you the differences between two versions of the page.
wiki:camera:3g:installation:sms_codes [2015/06/30 14:40] |
wiki:camera:3g:installation:sms_codes [2021/12/15 12:07] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== SMS COMMAND CODES ===== | ||
+ | The SMS Switch must be ON for the camera to receive text commands and | ||
+ | was previously covered under the WIRELESS menu tab. The M.I.N.E™ | ||
+ | Cam is able to receive text commands from up to four phone numbers to | ||
+ | perform 22 different functions remotely. All four phone numbers have the | ||
+ | ability to send and receive SMS commands to control the camera. \\ | ||
+ | |||
+ | We store camera SIM card numbers into our cell phones by trap number. | ||
+ | These are the most frequently used functions. The code to check Cellular | ||
+ | Signal Strength is ***150#**. The response from the camera is “The signal | ||
+ | is good.” A response of “The signal is weak” or “The signal is very weak” | ||
+ | indicates a 5 decibel booster antenna on a telescoping pole is needed. \\ | ||
+ | |||
+ | The code to check Battery Level is ***201#**. The response from the camera is | ||
+ | “Battery level 5” indicating a full charge. The camera will stop functioning at | ||
+ | “Battery level 1.” \\ | ||
+ | |||
+ | The camera cannot text video; only photos. The code to change camera | ||
+ | mode to photo is ***200# | ||
+ | mode”. \\ | ||
+ | |||
+ | The code to close the M.I.N.E.™ Gate or Activate the RF Trigger is ***777# | ||
+ | The response from the camera is “RF triggered”. This code is only a function | ||
+ | of the M.I.N.E.™ Camera. The I.C.E.™ Camera **does not** utilize an internal | ||
+ | transmitter. \\ | ||
+ | |||
+ | After the M.I.N.E.™ Gate has been closed, the camera will continue sending | ||
+ | photos from the increased motion at the trap enclosure. The code to turn | ||
+ | the Send Mode **Off** is ***140# | ||
+ | Photos will continue to be triggered and saved to the SD card unless the PIR | ||
+ | sensitivity is turned “OFF”. \\ | ||
+ | |||
+ | Future photos will not be sent until the Send Mode is returned to instant. The | ||
+ | code to change the Send Mode to Instant is *140#0#. The response from the | ||
+ | camera is “Send instant photo”. \\ | ||
+ | |||
+ | The command to add a new recipient phone number of 706-555-1212 is | ||
+ | ***100# | ||
+ | added”. Refer to page 25 of this operations manual for all 22 available SMS | ||
+ | codes. \\ | ||
+ | |||
+ | |||
+ | < | ||
+ | <p> | ||
+ | If you have any questions, refer to the <a href=" | ||
+ | (3G) Camera Operations Video</ | ||
+ | information. | ||
+ | </p> | ||
+ | </ | ||
+ | |||
+ | ---- | ||
+ | ---- | ||
+ | |||
+ | {{backlinks> |