This shows you the differences between two versions of the page.
wiki:camera:mine:installation:quick_setup [2015/06/29 07:37] |
wiki:camera:mine:installation:quick_setup [2021/12/15 12:07] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== CAMERA QUICK SETUP ===== | ||
+ | 1. Ensure selector switch is OFF and install 8 new AA lithium | ||
+ | batteries according to polarity symbols. \\ | ||
+ | 2. Insert an activated SIM card and formatted SD card (32GB | ||
+ | or smaller) into the appropriate camera slots. \\ | ||
+ | 3. Move the selector switch from OFF to SETUP. \\ | ||
+ | 4. The screen will display Checking then Searching as the | ||
+ | camera acquires a cellular signal. \\ | ||
+ | 5. The camera has successfully acquired a cellular signal | ||
+ | when six numbers or the service provider’s initials appear on | ||
+ | the display. Failure to connect will prevent the camera from | ||
+ | sending texts and photos via MMS. | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | **Note: Allow approximately 10-20 seconds for the camera | ||
+ | to acquire a cellular signal. If “LOGIN FAIL” appears on | ||
+ | the display, move the selector switch OFF and repeat | ||
+ | steps. The 5 db booster antenna (accessory) is necessary | ||
+ | for cellular operation in low signal areas.** | ||
+ | | ||
+ | 6. Place the camera at the target area at least five feet above | ||
+ | ground level using a T-Post and T-Post Camera Mount. This | ||
+ | will ensure the camera has the correct angle to trigger the PIR | ||
+ | motion sensor and IR illuminators are above the target area. \\ | ||
+ | 7. Slide the selector switch from **SETUP** to **ON**. Close and | ||
+ | latch the camera within ten seconds before the Ambient Light | ||
+ | Sensor LED stops blinking red and the PIR triggers a photo. \\ | ||
+ | 8. Ensure the camera takes a photo to verify it is positioned | ||
+ | and programmed correctly. The camera will take photos or | ||
+ | videos based on the **MENU** selections. The M.I.N.E.™ Cam is | ||
+ | now operational and active. \\ | ||
+ | |||
+ | **NOTE: If the Ambient Light Sensor LED does not stop | ||
+ | blinking, the selector switch is still in the SETUP position. | ||
+ | The camera must be ON to function.**\\ | ||
+ | < | ||
+ | < | ||
+ | with the entire M.I.N.E.™ Trapping System video series at: <a href=" | ||
+ | </ | ||
+ | |||
+ | ---- | ||
+ | ---- | ||
+ | |||
+ | {{backlinks> |