This shows you the differences between two versions of the page.
wiki:camera:mine:misc:care_and_maint [2015/06/29 00:17] |
wiki:camera:mine:misc:care_and_maint [2021/12/15 12:07] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== CARE AND MAINTENANCE ===== | ||
+ | **Exterior** \\ | ||
+ | 1. Inspect the outside of the camera body for any cracks which may cause water or moisture damage to electronics.\\ | ||
+ | 2. Check for condensation in both IR LED bank covers.\\ | ||
+ | 3. Ensure the antenna is not loose, bent, broken or cracked.\\ | ||
+ | 4. Wipe excess dirt from camera lens with a soft cloth and use a moist cotton swab with rubbing alcohol to thoroughly clean.\\ | ||
+ | 5. Apply even pressure to camera face and main body housing when closing to ensure proper alignment of waterproof seal. | ||
+ | 6. Ensure all three latches tightly secure camera housing.\\ | ||
+ | 7. Clean inside the ambient light sensor port and PIR cover.\\ | ||
+ | 8. Inspect the transmitter port cover for dry rot and damage. | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | **WARNING!** The transmitter plug must be removed before | ||
+ | accessing camera functions. Opening the camera while | ||
+ | the transmitter is plugged into the housing port may result | ||
+ | in damage to both the camera and transmitter. | ||
+ | |||
+ | **WARNING!** Removing screws from internal camera ports | ||
+ | will damage electronic components and void the warranty. | ||
+ | |||
+ | ---- | ||
+ | ---- | ||
+ | |||
+ | {{backlinks> |