Sidebar
wiki:mine_trap:installation:control_box:connect_rod
~~DISCUSSION:off~~
ATTACHING CONNECTING ROD TO LATCH
Notice the actuator arm has more than one inch of travel. The actuator
arm and connecting rod is shown below fully “IN” and fully “OUT”.
Do not secure the rod to the latch with the connecting arm all the way
out or it will hit the bracket on the latch assembly when triggered.
The
illustrations below show the proper setting on the right side of the
bracket. Using a 3/32 Allen wrench, turn the set screw inside the rod
adapter to secure the connecting rod to the
.
wiki/mine_trap/installation/control_box/connect_rod.txt · Last modified: 2021/12/15 12:07 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
