This shows you the differences between two versions of the page.
wiki:mine_trap:installation:control_box:connect_rod [2015/05/25 09:57] |
wiki:mine_trap:installation:control_box:connect_rod [2021/12/15 12:07] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ~~DISCUSSION: | ||
+ | ===== ATTACHING CONNECTING ROD TO LATCH ===== | ||
+ | |||
+ | Notice the actuator arm has more than one inch of travel. The actuator | ||
+ | arm and connecting rod is shown below fully “IN” and fully “OUT”. | ||
+ | Do not secure the rod to the latch with the connecting arm all the way | ||
+ | out or it will hit the bracket on the latch assembly when triggered.{{: | ||
+ | ---- | ||
+ | The | ||
+ | illustrations below show the proper setting on the right side of the | ||
+ | bracket. Using a 3/32 Allen wrench, turn the set screw inside the rod | ||
+ | adapter to secure the connecting rod to the \\ {{: | ||
+ | ---- | ||
+ | ---- | ||
+ | |||
+ | {{backlinks> |