http://southernhogcontrol.net/wiki/ 2026-05-01T13:33:18+00:00 http://southernhogcontrol.net/wiki/ http://southernhogcontrol.net/wiki/lib/tpl/dokuwiki/images/favicon.ico text/html 2021-12-15T12:07:32+00:00 Anonymous (anonymous@undisclosed.example.com) http://southernhogcontrol.net/wiki/doku.php/wiki:mine_trap:installation:control_box:antenna_mount?rev=1639588052&do=diff ~~DISCUSSION:off~~ MOUNTING ANTENNA TO CONTROL BOX Carefully feed the antenna through the rubber grommet without damaging the receiver inside the control box. Feed the antenna wire through the 1/8” diameter antenna tube until it clears the opposite end. text/html 2021-12-15T12:07:32+00:00 Anonymous (anonymous@undisclosed.example.com) http://southernhogcontrol.net/wiki/doku.php/wiki:mine_trap:installation:control_box:connect_rod?rev=1639588052&do=diff ~~DISCUSSION:off~~ ATTACHING CONNECTING ROD TO LATCH Notice the actuator arm has more than one inch of travel. The actuator arm and connecting rod is shown below fully “IN” and fully “OUT”. Do not secure the rod to the latch with the connecting arm all the way out or it will hit the bracket on the latch assembly when triggered. text/html 2021-12-15T12:07:32+00:00 Anonymous (anonymous@undisclosed.example.com) http://southernhogcontrol.net/wiki/doku.php/wiki:mine_trap:installation:control_box:install_rods?rev=1639588052&do=diff ~~DISCUSSION:off~~ INSTALLING CONNECTING ROD & CLEVIS Push the 1/8” connecting rod through the plastic clevis. Slide the connecting rod through the actuator hole inside the control box. Align the slots and gently snap the clevis onto the actuator arm.