http://southernhogcontrol.net/wiki/ 2026-04-19T03:11:30+00:00 http://southernhogcontrol.net/wiki/ http://southernhogcontrol.net/wiki/lib/tpl/dokuwiki/images/favicon.ico text/html 2021-12-15T12:07:33+00:00 Anonymous (anonymous@undisclosed.example.com) http://southernhogcontrol.net/wiki/doku.php/wiki:mine_trap:installation:gate:operation?rev=1639588053&do=diff ~~DISCUSSION:off~~ TESTING GATE OPERATION Ensure the trip arm is in the fully upright position. Raise the gate with both hands. Hold the gate in the fully raised position with the left hand and lower the trip arm’s striker into the latch with the right hand. Ensure the latch is fully closed by pressing the latch arm upward. text/html 2021-12-15T12:07:33+00:00 Anonymous (anonymous@undisclosed.example.com) http://southernhogcontrol.net/wiki/doku.php/wiki:mine_trap:installation:gate:timing?rev=1639588053&do=diff ~~DISCUSSION:off~~ TIMING TRANSMITTER TO RECEIVER The long range transmitter frequencies are timed to the receiver during assembly and quality control. Users may time transmitters to multiple receivers to close more than one gate on a trap enclosure. Timing the M.I.N.E. camera to the control box is covered in the M.I.N.E. camera’s Operations Manual. text/html 2021-12-15T12:07:34+00:00 Anonymous (anonymous@undisclosed.example.com) http://southernhogcontrol.net/wiki/doku.php/wiki:mine_trap:installation:gate:trigger?rev=1639588054&do=diff ~~DISCUSSION:off~~ ADJUSTING TRIGGER ASSEMBLY Loosen the trigger assembly nuts with a 9/16” wrench. Adjust the trigger assembly left or right until the trigger square stock is sitting on the outside edge of the trip arm. Then tighten the trigger assembly nuts with a 9/16”