Sidebar
wiki:mine_trap:installation:gate:trigger
~~DISCUSSION:off~~
ADJUSTING TRIGGER ASSEMBLY
| Loosen the trigger assembly nuts with a 9/16” wrench. |  |
| Adjust the trigger assembly left or right until the trigger square stock is sitting on the outside edge of the trip arm. Then tighten the trigger assembly nuts with a 9/16” wrench. The trigger is set at the factory and should not require adjustment. |  |
| Lightly tighten the bolt and nut on the trip arm using a 1/2” wrench and socket so the trip arm stays in the “up” position without falling, but can still easily move. |  |
| Work the trip arm up and down onto the latch to ensure there is no binding. |  |
 It is important the trip arm stays in the “up” position without falling. This step allows the use of both hands to raise the gate. |  |
.
wiki/mine_trap/installation/gate/trigger.txt · Last modified: 2021/12/15 12:07 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
