|Loosen the trigger assembly nuts with a |
|Adjust the trigger assembly left or right until |
the trigger square stock is sitting on the
outside edge of the trip arm. Then tighten
the trigger assembly nuts with a 9/16”
wrench. The trigger is set at the factory
and should not require adjustment.
|Lightly tighten the bolt and nut on the |
trip arm using a 1/2” wrench and socket
so the trip arm stays in the “up” position
without falling, but can still easily move.
|Work the trip arm up and down onto the |
latch to ensure there is no binding.
It is important the trip arm stays
in the “up” position without falling. This
step allows the use of both hands to raise